XLS 802D Power Amplifier

1,050W/ch @ 2 ohms, 800W/ch @ 4 ohms, 500W/ch @ 8 ohms, 2,100W bridged mono @ 4 ohms, 1,600W bridged mono @ 8 ohms. Designed to provide the quality, power, and reliability you expect from other Crown amps with many of the same controls and features for a much friendlier price. Features sophisticated protection circuitry (from shorted, open, or mismatched loads, input and high frequency overloads), 5-way fault indicator, red LED on each channel that turns on when distortion becomes audible, green signal-present LED that flashes when the level is extremely low (indicating cabling problems), and detented level controls. Mode select switch for stereo or bridged; 3-speed fan; XLR inputs and Speakon or binding post outputs; all in a rugged steel chassis designed to handle serious road use. Features sophisticated protection circuitry 5-way fault indicator Red peak clip LED on each channel Green signal-present LED that flashes when the level is extremely low Detented level controls Mode select switch for stereo or bridged 3-speed fan XLR inputs Touchproof binding post and Speakon outputs All in a rugged steel chassis designed to handle serious road use 3-year no-fault warranty. Sensitivity (volts RMS) for full rated power at 4 ohms: 1.25 V. Frequency Response (at 1 watt) 22 Hz to 20 kHz: +0 dB, —0.8dB Signal-to-Noise Ratio (20 Hz to 20 kHz)_A-weighted, below rated power: _>98 dB. _No weighting, below rated power: _>93 dB. Total Harmonic Distortion (THD): <0.5%. Intermodulation Distortion (IMD):_(60 Hz and 7 kHz at 4:1) from full rated output to —40 dB: < 0.3%. Damping Factor (8 ohm) 10 Hz to 400 Hz: >200. Crosstalk (below rated power)_at 1 kHz: —76 dB. at 20 kHz: —58 dB. Input Impedance (nominal): 20 kilohms balanced, 10 kilohms unbalanced. Load Impedance: Rated for 2 to 8 ohms per channel in Stereo, 4 to 8 ohms in Bridge Mono. AC Line Voltage and Frequency Configurations Available (±10%): 120 VAC 60 Hz, 100 VAC 50/60 Hz, 220 VAC 50 Hz, and 230-240 VAC 29.0 lbs